View source for nokia aggregate interface setup via CLI

set member interface parameters, then must all match
 clish -c "set interface eth-s4p2 duplex full"
 clish -c "set interface eth-s4p3 duplex full"
 clish -c "set interface eth-s4p4 duplex full"
 clish -c "set interface eth-s4p2 speed 1000M"
 clish -c "set interface eth-s4p3 speed 1000M"
 clish -c "set interface eth-s4p4 speed 1000M"

add interfaces above to group (need to create group 1st?... not sure)
 clish -c "add linkaggregation group 1"
 clish -c "add linkaggregation group 1 port eth-s4p2 type primary"
 clish -c "add linkaggregation group 1 port eth-s4p3"
 clish -c "add linkaggregation group 1 port eth-s4p4"

configure aggregate interface 
 clish -c "set interface ae1 active on"
 clish -c "set interface ae1 duplex full"
 clish -c "set interface ae1 speed 3000M"
 clish -c "set interface ae1c0 logical-name ae1c0"
 clish -c "add interface ae1c0 address 10.206.15.1/30"

[[category:nokia]]