cisco asa notes - Revision history

Nighthawk at 18:54, 24 June 2024

2024-06-24T18:54:53Z

Nighthawk at 04:41, 20 June 2024

2024-06-20T04:41:25Z

Nighthawk: Created page with "==Getting Started== Accessing the Appliance Command-Line Interface This following prompt indicates that you are in user EXEC mode. Only basic commands are available from user..."

2024-06-20T03:16:13Z

Created page with "==Getting Started== Accessing the Appliance Command-Line Interface This following prompt indicates that you are in user EXEC mode. Only basic commands are available from user..."

New page

==Getting Started==
Accessing the Appliance Command-Line Interface

This following prompt indicates that you are in user EXEC mode. Only basic commands are available from user EXEC mode.
hostname>

To access privileged EXEC mode, enter the following command:
hostname> '''enable'''

The prompt changes to the following:
hostname#

To exit privileged mode, enter the disable, exit, or quit command.

access global configuration mode
hostname# '''configure terminal'''

The prompt changes to the following:
hostname(config)#

← Older revision		Revision as of 18:54, 24 June 2024
Line 51:		Line 51:
	save config		save config
	hostname(config)# '''write memory'''		hostname(config)# '''write memory'''
		+
		+	==VM notes==
		+
		+	KVM graphical console stops after...
		+	Booting the kernel.
		+
		+	at this point he VM is outputing to the virtual serial console. There are similar experiences on VMware.

@@ Line 1: / Line 1: @@
 ==Getting Started==
-Accessing the Appliance Command-Line Interface
+===Accessing the Appliance Command-Line Interface===
 This following prompt indicates that you are in user EXEC mode. Only basic commands are available from user EXEC mode.
@@ Line 18: / Line 18: @@
 The prompt changes to the following:
   hostname(config)#