Difference between revisions of "nokia aggregate interface setup via CLI"
From cpwiki.net
(Created page with "set member interface parameters, then must all match clish -c "set interface eth-s4p2 duplex full" clish -c "set interface eth-s4p3 duplex full" clish -c "set interface eth...") |
Revision as of 14:41, 3 July 2013
set member interface parameters, then must all match
clish -c "set interface eth-s4p2 duplex full" clish -c "set interface eth-s4p3 duplex full" clish -c "set interface eth-s4p4 duplex full" clish -c "set interface eth-s4p2 speed 1000M" clish -c "set interface eth-s4p3 speed 1000M" clish -c "set interface eth-s4p4 speed 1000M"
add interfaces above to group (need to create group 1st?... not sure)
clish -c "add linkaggregation group 1" clish -c "add linkaggregation group 1 port eth-s4p2 type primary" clish -c "add linkaggregation group 1 port eth-s4p3" clish -c "add linkaggregation group 1 port eth-s4p4"
configure aggregate interface
clish -c "set interface ae1 active on" clish -c "set interface ae1 duplex full" clish -c "set interface ae1 speed 3000M" clish -c "set interface ae1c0 logical-name ae1c0" clish -c "add interface ae1c0 address 10.206.15.1/30"
