61k CMM

Chassis Management Module CLI

The Chassis Management Module (CMM) monitors and controls hardware modules in the chassis. Communication with a CMM occurs via SNMP requests from the SMO SGM. If a hardware sensor reports a problem the CMM automatically takes action or sends a report. CMMs also have a command line interface. There are two ways to connect a CMM CLI:

1) Connect to the serial port on the front panel of the CMM

• In your terminal emulation program, set the baud rate to 9600
• Enter admin for the user name and password

OR

2) Open a telnet or SSH session from one of the SGMs

• First make sure that you have connectivity to the CMMs by pinging both

addresses:

198.51.100.33 (routed via SSM1)

198.51.100.233 (routed from SSM2)

• Telnet or ssh from the SGM to the CMM
• Enter admin for the user name and password

note - the information above is base on default configurations