nokia aggregate interface setup via CLI

From cpwiki.net
Revision as of 14:41, 3 July 2013 by Nighthawk (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Check Point Profressional Services

set member interface parameters, then must all match 

clish -c "set interface eth-s4p2 duplex full"
clish -c "set interface eth-s4p3 duplex full"
clish -c "set interface eth-s4p4 duplex full"
clish -c "set interface eth-s4p2 speed 1000M"
clish -c "set interface eth-s4p3 speed 1000M"
clish -c "set interface eth-s4p4 speed 1000M"

add interfaces above to group (need to create group 1st?... not sure) 

clish -c "add linkaggregation group 1"
clish -c "add linkaggregation group 1 port eth-s4p2 type primary"
clish -c "add linkaggregation group 1 port eth-s4p3"
clish -c "add linkaggregation group 1 port eth-s4p4"

configure aggregate interface  

clish -c "set interface ae1 active on"
clish -c "set interface ae1 duplex full"
clish -c "set interface ae1 speed 3000M"
clish -c "set interface ae1c0 logical-name ae1c0"
clish -c "add interface ae1c0 address 10.206.15.1/30"
Retrieved from "http://www.cpwiki.net/index.php?title=nokia_aggregate_interface_setup_via_CLI&oldid=156"